DreamLine DL-6184-01 Installationsanleitung

QWALL – 4 & SlimLine Shower Base Kit ACRYLIC SHOWER WALL AND SHOWER BASE KIT INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the righ

Ver. 1, Rev. 1 9 Fig. 11 9. Mount the Corner cover (02) to the corner of the shower using the Countersunk screws ST4.2×3

Ver. 1, Rev. 1 10 Fig. 13 10. Apply the sealant to the entire surface of the reverse side of the Side panel (01). Also, ap

Ver. 1, Rev. 1 11 11. Slide the narrow edge of the Side panel (01) behind the Corner cover (02). Align trimmed edge of the Side panel (from Step. 4) w

Ver. 1, Rev. 1 12 14. Once Side panels (01) aligned, fasten tight the Corner cover (02) to secure the Side panels. Cover the screw holes with the Dec

Ver. 1, Rev. 1 13 16. Apply caulk along the top edge of the Side panels (01) and along the connection of the bottom edges of the Side panels with the

Ver. 1, Rev. 1 14 18. Mark the location for the Shelf brackets (04) according to the measurements in Fig. 20 and Fig. 21.1. Drill the holes using Ø5/1

Ver. 1, Rev. 1 15 Fig. 23 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off afte

SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or re

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 2 Preparation 1. Prior to installation, examine all boxes and packages for shipping damage

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 3 SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in) D1

Ver. 1, Rev. 1 QWALL – 4 ACRYLIC SHOWER WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign produc

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 4 SINGLE THRESHOLD SHOWER BASE Left-Hand Drain Configuration

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 5 SINGLE THRESHOLD SHOWER BASE Right-Hand Drain Configuration

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 6 NEO ANGLE SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) D

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 7 QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 8 DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C (

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 9 DOUBLE THRESHOLD SHOWER BASE Left-Hand Drain Configuration MODEL SPECIFICATION D (i

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 10 DOUBLE THRESHOLD SHOWER BASE Right-Hand Drain Configuration MODEL SPECIFICA

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 11 Shower Base Cross Section Diagram Finished Wall Cement board Shower Base

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 12 Shower Base Installation - Preparation 1. Ensure that the floor and the studs are at right angles.

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 13 2. Install the shower drain (NOT INCLUDED) according to the drain installation manual (supplied wit

Ver. 1, Rev. 1 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inclu

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See F

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 15 6. After the bedding material has been poured and before it sets, place the shower base

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015 16 Product maintenance To ensure long lasting life for your acrylic back walls, wi

DREAMLINE™ EXCLUSIVE LIMITED WARRANTY AS OF MAY 6, 2013 This warranty extends only to the original owner/end‐user for household use only and is not

TEL: 866-731-2244 FAX: 866-857-3638 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Bases please

Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 56784213 Packing List 01 Side panel 2pcs 05 Glass shelf 2pcs 02 Corner cover

Ver. 1, Rev. 1 4Preparation for Installation of Side Panel ATTENTION: See Fig. 1 for details. Fig. 1 1. Place a mark on the

Ver. 1, Rev. 1 5 2. Measure the walls of the shower from the 1” (one inch) line in the corner (from Step. 1) to the points where you want Side panels

Ver. 1, Rev. 1 6 4. Place the Side panel (01) on a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score alon

Ver. 1, Rev. 1 7 5. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the corner of the shower to the fixture:

Ver. 1, Rev. 1 8 7. Drill the holes for the fixtures in the Side panel (01) using the proper diameter saw bit or a handheld jig saw. See Fig. 9 for